Sunwexplo Package Solaris 10 How To Configure Hardware

Java is required for telnet and SSH connections, therefore Java (JRE 1.4.00 or higher) must be installed on the server.

They are actually very similar to the classic UltraSPARC (II, III, IV) architectures except for the processor which has been designed for massively parallel operations: Each SPARC T1 processors has 24 individual cores clocked at 1GHz.

Even worse: the installation of the SMC environment requires deep knowledge of the SMC architecture and internals.

Hardware Sentry does not need and thus does not use the SMC agent to discover and monitor the hardware components of Sun Solaris systems (sun4v).

This management card provides much detailed information about the internal hardware components of sun4v systems, including the environment (temperature sensors, voltage sensors, current sensors, fans, power supplies and internal hard drives).

In order to communicate with the ALOM card in-band, Sun Explorer requires root privileges.

Please follow the instructions of the Installation Guide of Hardware Sentry.

To ensure that Hardware Sentry can use these utilities to discover and monitor the hardware components of a Sun server (sun4u), you can either configure Hardware Sentry to execute all of its external commands as root or configure it to use the sudo utility for a specified list of commands.

Then select which commands Hardware Sentry will use sudo for.

But this list is not exhaustive and also depends on the version of Solaris.

The best way to know for sure if the ndd will be used on a Solaris system is to check whether Hardware Sentry is able to collect the LinkStatus parameter without root privileges.

In this case, there is nothing that can be done to fix the problem.

Sentry Software however plans to release a new connector based on the fmstat Solaris utility for Solaris 10 systems.

You can force Hardware Sentry to discover non-Sun disks by manually selecting the Sun Solaris - Non-Sun Disks through the graphical user interface of the KM.

The potential drawback of this is that Hardware Sentry could take some external disks (in an external SAN array for example) as real physical disks and thus create dozens of instances for all of these disks.

Since there is a status reported for each core of each processor, Hardware Sentry has been designed to report these status parameters for each core, instead of each physical processor package.

This is a design choice and there is not much to do to correct it.

One instance of the KM will be configured to monitor the system in-band (processors, network cards and physical disks) and another instance of the KM will be configured to monitor the system out-of-band, i.e.

ALOM card over the network and gather the environment information.

The Solaris server must be able to communicate with the ALOM card through TCPIP.

Sunwexplo Package Solaris 10 How To Configure Hardware

Please read carefully the previous section about sun4u systems to learn more about how to configure Hardware Sentry to properly monitor the processors, physical disks and network cards of Sun Solaris systems.

Specify Out-of-band Management Card for the element type and click Next.

Under this icon, you will find the hardware components as seen through the ALOM card.

Install Sunwexplo Package Solaris 10